您好,歡迎光臨萊州中科聚峰有限公司網站! 主營自動攪拌車,攪拌一體車,自動上料攪拌車等各種規格的產品。
15098551508
自動上料攪拌車行業持續領跑者!
點擊撥打服務熱線:4008791999

您的位置:首頁 - 技術問答 > 行業資訊 >

行業資訊

自上料攪拌車的油品什么時候更換?

發布時間:2021-01-27 來源:http://www.pembeyol.com/ 瀏覽量:

概述:普通的潤滑油產品在氣溫低的情況下則變得更稠,流動性減弱,達到需要潤滑部位的時間加長,致使車輛不易啟動且磨損加大,這對發動機可是非常
普通的潤滑油產品在氣溫低的情況下則變得更稠,流動性減弱,達到需要潤滑部位的時間加長,致使車輛不易啟動且磨損加大,這對發動機可是非常不利的。自動混凝土攪拌車機油什么時候更換,要選擇什么類型的機油呢?小編提醒您有四點需要注意:
Ordinary lubricating oil products become thicker at low temperature, the fluidity is weakened, and the time to reach the lubrication parts is longer, which makes the vehicle difficult to start and the wear is increased, which is very unfavorable to the engine. When to change the engine oil of automatic concrete mixer and what type of engine oil to choose? Xiaobian reminds you of four points to pay attention to:
1. 盡量選擇冬夏通用的機油,通用機油無論溫度怎么變化,都能保持比較穩定的潤滑性能,對發動機能夠起到較好的保護作用。
1. Try to choose the general engine oil in winter and summer. No matter how the temperature changes, the general engine oil can maintain a relatively stable lubrication performance, which can play a better role in protecting the engine.
2. 要根據發動機的要求選擇潤滑油,既不能在要求較低的發動機適用過于較好的機油,也不能將低級的機油使用在要求較高的發動機上,總之,發動機的機油選擇要恰當。
2. The lubricating oil should be selected according to the requirements of the engine. Neither too good engine oil should be applied to the engine with lower requirements, nor low-grade engine oil should be used to the engine with higher requirements. In a word, the engine oil selection should be appropriate.
               自動上料攪拌車
3. 自動混凝土攪拌車要根據發動機的狀況來選擇,如果發動機是新的或者狀況良好的,要盡可能選用粘度較低的機油,從而保證潤滑油的流動暢通無阻,有效減少啟動時的磨損。
3. The automatic concrete mixer should be selected according to the condition of the engine. If the engine is new or in good condition, the engine oil with lower viscosity should be selected as far as possible, so as to ensure the smooth flow of lubricating oil and effectively reduce the wear during starting.
4. 如果在高溫季節或發動機已經磨損到一定程度,就要選用高粘度的機油,這樣才能有利于形成較厚的油膜,維持機油的壓力,并減少機油消耗。
4. If the engine has been worn to a certain extent in the high temperature season, it is necessary to choose high viscosity oil, which is conducive to the formation of a thicker oil film, maintaining the oil pressure and reducing oil consumption.
5.機油的添加量不能過多,機油添加量并不是越多越好,如果潤滑油過多,就會增加曲軸的轉動阻力,降低發動機的輸出功率,并且哪些過量的機油會竄入燃燒室燃燒,造成車輛燒機油,冒藍煙,以至于油耗增加。所以在添加機油的時候,一定要略低于機油尺以高刻度為宜;此外還要掌握機油的型號、換油的季節、發動機的性能等諸多因素。
5. The amount of oil should not be too much. The more the oil is added, the better. If there is too much lubricating oil, it will increase the rotation resistance of the crankshaft and reduce the output power of the engine. What excess oil will rush into the combustion chamber and cause the vehicle to burn oil and emit blue smoke, so that the fuel consumption will increase. Therefore, when adding engine oil, it must be slightly lower than the oil dipstick, and the high scale is appropriate; in addition, it is necessary to master many factors, such as the type of engine oil, the season of oil change, the performance of the engine, etc.
技術支持:濟南諾商  XML   TXT   
本網站部分資源來自互聯網,如有侵權,請聯系我們及時刪除
分享按鈕

截屏,微信識別二維碼

微信號:

點擊微信號復制,添加好友

 打開微信

日本阿v不卡高清在线播放_2019久久久高清456_被公每天都侵犯的我正在播放